Purchased equipment: boiler flue gas waste heat utilization
Location: WUXI China
Telephone: +86 13861509127
E-mail: [email protected]
Contact us for more details about our boilers, solutions and services.

boiler flue gas waste heat utilization
Others

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

Technical advantages

Digitized manufacture

  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of square coil tube adopts CNC three-dimensional tube bending machine, no forced shaping.
  • The manufacture of serpentuator adopts serpentuator automatic production line, once-forming.

Long life span

  • The optimized radiation heating surface and convective heating surface, the medium flow is more reasonable, without overheat of the carrier and reduce the life;
  • Convection section: optimize convection heating surface and adopt effective fix and structural support to make its working life longer.
  • Set up effective flue gas partition for convection heating surface and cast partition to make it works longer.

Less fuel consumption

  • Use superior refractory brick to build inside and superior perlite in the middle. Keep the furnace temperature under 50℃ to make the minimization of loss.
  • Furnace adopts double close line coil, which makes heating surface sufficient.

Add Comment

Flue Gas Waste Heat Boiler Thermal Efficiency Calculati

Flue Gas Waste Heat Boiler Thermal Efficiency Calculation 2017-10-04 17:02:11 Boiler heat efficiency refers to the heat input into the boiler, most of which are absorbed by the boiler heating surface to produce water vapor, which is the heat that is effectively utilized, and the remaining heat is called heat loss.

7 Ton Condensing Gas Steam Boiler In Cai Tongdetan

The condenser can increase the boiler thermal efficiency to 104% through the full utilization of flue gas waste heat, the fuel is used more fully, and the exhaust gas temperature is also greatly reduced, meeting the demand of Cai Tongdetang Pharmaceutical.

Research and Application of in-Depth Boiler Flue Gas Wast

Cite this article: CHANG Haiqing,ZHANG Yan. Research and Application of in-Depth Boiler Flue Gas Waste Heat Utilization and Emission Reduction Technology[J].

Flue Gas Heat RecoveRy - Bilfing

PoWeRIse® recover the waste heat from the flue gas before entry into the flue gas desulphurization system (FGD) to preheat feedwater and air. the valuable extraction steam of the turbine used up to now for this purpose con-tributes to power generation in addition. Heat recovery systems have been proved successful in

30-100 tons of vertical waste pyrolysis and gasification plan

adopts high quality flue gas purification equipment and efficient utilization of waste heat boiler, constitute the very project construction and operation cost advantage,

The Potential and Approach of Flue Gas Waste Hea

The Approach of Flue Gas Waste Heat Utilization of Natural Gas for Space Heating 3.1. The flue gas heat recovery method for gas boiler We all know that, the return temperature of the heating system is always above 50 ºC, so the flue gas temperature cannot be decreased to below 50ºC, and the condensing heat of the flue gas cannot be fully

Discussion on Waste Heat Utilization System of Coal-Fire

Discussion on Waste Heat Utilization System of Coal-Fired Utility Boilers: LIU Yugang 1, 2, YI Guangzhou 1, 2: 1. Clean Combustion and Flue Gas Purification Key Laboratory of Sichuan Province, Chengdu 611731, China; 2. Dongfang Boiler Group Co., Ltd., Zigong 643001, China

The Potential and Approach of Flue Gas Waste Hea

The Approach of Flue Gas Waste Heat Utilization of Natural Gas for Space Heating 3.1. The flue gas heat recovery method for gas boiler We all know that, the return temperature of the heating system is always above 50 ºC, so the flue gas temperature cannot be decreased to below 50ºC, and the condensing heat of the flue gas cannot be fully

Flue Gas Analysis of a Small-Scale Municipal Solid Wast

utilization of these resources, adequate design of municipal solid waste - fired steam boiler is necessary in order to extract heat produced in the combustion of waste, considering the calculated high calorific value of MSW and the availability of this material around us.

boiler flue gas waste heat recovery system product

There are still many problems in the use of industrial boiler, just like the low utilization of existent heat, the high temperature of the flue gas waste heat, the high content of air pollution and so on.

Waste heat recovery and utilization system of boiler flu

Waste heat recovery and utilization system of boiler flue gas. Because there are some design and installation defects in the early design and installation of the boiler, in the long-term operation of the later boiler, the ash accumulation, wear and tear in the boiler and the deviation of coal quality from the design value are the main factors affecting the boiler.

text